MEGA Corp. MMP4-2 - Manual (Page 14)

MMP 4-2
5 Nov 2011
SECTION 3
Engine Control System
3-3
6. Install new throttle cable assembly in
mounting bracket.
7. Thread jam nut on throttle cable adjusting
end behind mounting bracket.
8. Route throttle cable to the fuel pump cable
mounting bracket.
9. Run cable through fuel pump mounting
bracket.
10. Install jam nut on fuel pump throttle lever
side of bracket.
11. Insert throttle cable in the pivot on the
throttle lever of the fuel pump.
12. Ensure throttle cable and fuel pump throttle
lever is in the idle position.
13. Secure the throttle cable locking screw on
the new cable.
14. Ensure the new throttle cable is routed
away from moving parts.
15. Ensure throttle cable is secure.
16. Check operation of newly installed cable
for smooth operation.
17. Ensure newly installed throttle cable allows
engine throttle lever to fully contact the
LOW idle stop.
18. Ensure the newly installed throttle cable
allows engine throttle to fully contact the
HIGH idle stop.