Setting up tv1 to operate in ir (default) – Dish Network 512 User Manual

Page 40

Page 35

Setting Up TV1 to Operate in IR (default)

The following instructions describe how to set up TV1 to operate in IR only,

which is the default.

1. Perform the following with an existing linked remote control:

a. Open the

TV1 UHF Pro Setup

screen by pressing MENU-6-1-6 on the

remote control.

b. Select

Disable

from the

TV1 UHF Pro Setup

screen.

c. Select

System Info

to open the

System Information

screen.

2. Perform the following with an IR remote control, such as a Remote Control

5.4 (as shown in the writing on the back of the remote), that you intend to
use to control TV1:

a. Press the RECORD button. The

Done

button should be highlighted.

b. Make sure the

System Information

screen shows that the

Primary

Remote Address

indicates