Setting up tv1 to operate in uhf pro – Dish Network 512 User Manual
Page 39
Chapter 2
Page 34
Receiver Description and Installation
Setting Up TV1 to Operate in UHF Pro
You can set your receiver to operate TV1 using an optional IR/UHF Pro remote
control (sold separately) by completing the following instructions:
1. Perform the following using an existing remote control:
a. Open the
TV1 UHF Pro Setup
screen by pressing MENU-6-1-6 on the
remote control.
b. Select
Enable
from the
TV1 UHF Pro Setup
screen.
c. Select
System Info
to open the
System Information
screen.
d. Move the highlight to the address for the
Primary Remote Address
as
shown below.
2. Perform the following steps using the UHF Pro remote that you are going to
use to control TV1:
a. Press and hold the SAT mode button about three seconds, until all the
mode buttons light up, and then release the SAT button. The SAT mode
button begins to blink.
b. Use the NUMBER PAD buttons to enter any number from 1 to 16. The
SAT mode button goes blinks as you enter each digit, then remains lit.
Write down the number you entered:
c. Press the POUND (#) button. If you entered the address correctly, the
SAT mode button will flash three times.
d. Press the RECORD button.
e. Make sure the
System Information
screen shows that the
Primary
Remote Address
indicates
UHF Pro and IR
, and that this address
matches the number that you wrote down in step b.
If you set up your receiver to operate tuner
using UHF Pro,
any other UHF Pro remotes in the building will interfere with
each other when operated at the same time. This may prevent
remotes from operating the receiver momentarily.
Note: Highlight the
Primary Remote
Address.