Dish Network 512 - Manual (Page 100)

Page 95
Testing the System
4. Press the 0 number button.
5. Press the POUND (#) button.
The TV mode button flashes three times.
6. Press the SAT mode button.
7. Press the plus (+) and minus (-) sides of the VOLUME
button.
The TV’s volume changes and the TV mode button
flashes instead of the AUX mode button.
Testing the System
Starting a Test
Press MENU 6-3 to access the Diagnostics menu. You will see several options
available for testing your DVR receiver.
Telephone Connection Test
This test checks that the receiver telephone connection is working. Select the
Connection option to begin the test. The receiver displays a message asking
you to wait until the test is done.
• If the telephone connection is correct, then the receiver displays a Phone
Connection OK message.
• If the receiver highlights the Done option, then select the Dial Out option so
the receiver can make a toll-free call to the Customer Service Center. Press
the remote control SELECT button to start the call. The receiver displays a
message asking you to wait until the call is done. When the call is done,
select the Done option to exit the test menu.
• If the telephone line is not connected properly, then the receiver displays a
failure message. In this case, check the telephone connection and line, and
then repeat the test.
Note : If you have the receiver connected to a DSL (Digital Subscriber Line)
phone line, it may cause this test to fail. If so, you will need to install a DSL
filter between the receiver and the telephone jack on the wall. You should be
able to get a DSL filter from your DSL provider or your local electronic-
parts store.