Marantz PS-17 - Manual (Page 15)

5
ENGLISH
DISPLAY
(1) Main Information Display
This display shows messages relating to the status, input source,
surround mode, volume level or other aspects of unit’s operation.
(2) ENCODED SIGNAL indicators
2 DIGITAL, 2 SURROUND, dts and PCM
When the selected input is a digital source, one of these indicators
will light to display the specific type of signal in use.
(3) ANALOG : Analog Input Indicator
This indicator lights when an analog input source has been selected.
(4) DIRECT : SOURCE DIRECT Indicator
This indicator lights when the PS-17 is in the SOURCE DIRECT mode.
(5) SLEEP Indicator
This indicator lights when the Sleep function is in use.
(6) COPY Indicator
This indicator lights when DIGITAL COPY system is active.
(7) D.H mark : DOLBY HEADPHONE
Indicator
This indicator lights when headphones are used and the Dolby
Headphone function is activated.
(8) NIGHT Mode Indicator
This indicator lights when the PS-17 is in the Night mode, which
reduces the dynamic range of digital program material at low volume
levels.
(9) EQ : HT-EQ (Home Theater EQ)
indicator
This indicator lights when HT-EQ is active.
(10) PEAK indicator
This indicator is a monitor for an analog audio input signal. If the
selected analog audio input signal is greater than the capable level of
internal processing, this will light. If this happens, you should press
the
ATT button on the remote controller.
(11) ATT : Attenuation indicator
This indicator lights when the attenuation function is active.
(12) ENCODED CHANNEL STATUS indicators
These indicators display the channels that are encoded with a digital
input signal. If the selected digital input signal is Dolby Digital 5.1ch
or DTS 5.1ch, “L”, “C”, “R”, “LS”, “RS” and “LFE” will light up.If the
digital input signal is 2 channel PCM-audio, “L” and “R” will be
displayed. If Dolby Digital 5.1ch signal with Surround EX flag comes
in, “L”, “C”, “R”, “LS”, “S” , “RS” and “LFE” will show.