• By default, the volume setting when power was previously set to standby is applied at next power on. To use a fixed volume level, set the volume level

at power on for “Volume Limit” in the menu. You can set this for each zone (vpage 144, 178).

I want to have the subwoofer always output audio.

• Depending on the input signals and sound mode, the subwoofer may not output audio.

When “Subwoofer Mode” in the menu is set to “LFE+Main”, you can have the subwoofer always output audio (vpage 172).

I want to make human voices in the movies clearer.

• Use “Dialog Level” in the menu to adjust the level (vpage 139).

I want to keep bass and clarity during playback at a lower volume level.

• Set “Dynamic EQ” in the menu to “On”. This setting corrects the frequency characteristics to allow you to enjoy clear sound without the bass being

lost even during playback at a lower volume level (vpage 145).

I want to automatically adjust the volume level difference in content such as TV and movies.

• Set “Dynamic Volume” in the menu. Volume level changes (between quiet scenes and loud scenes) in TV shows or movies are automatically adjusted

to your desired level (vpage 146).

I want to set the optimized listening environment after changing the configuration/position of the speakers or

changing a speaker to a new one.

• Perform Audyssey® Setup. This automatically makes the optimized speaker settings for the new listening environment (vpage 158).