Kemppi Protig 501L - Manual (Page 31)

PROMIG 501, PROMIG 511/0537 – 31 © KEMPPI OY
7. SERVICE, OPERATION DISTURBANCES
The amount of use and the working environment should be taken into consideration when
planning the frequency of maintenance of PROMIG. Careful use and preventive maintenance
will help to ensure trouble-free operation.
The following maintenance operations should be carried out at least every six months:
Check:
– The wear of the grooves of the feed rolls. Excessive wear of grooves
causes problems in wire feed.
– The wear of the wire guide tubes of wire feed. Badly worn feed
rolls and wire guide tubes should be discarded.
– The wire guide tube in the gun should be set as near the feed rolls
as possible, but not touching them and the wire must follow a straight
line from the end of the tube to the groove of the feed roll.
– Reel brake adjustment.
– Electric connections
* Oxidized couplings must be cleaned
* Loose couplings must be tightened
Clean dust and dirt from the equipment.
twice a
year
When using compressed air, always protect your eyes with proper eye protection.
In case of problems contact your KEMPPI dealer.
8. DISPOSAL OF THE MACHINE
Do not dispose of electrical equipment together with normal waste!
In observance of European Directive 2002/96/EC on Waste Electrical and Electronic
Equipment and its implementation in accordance with national law, electrical equipment
that has reached the end of its life must be collected separately and returned to an
environmentally compatible recycling facility. As the owner of the equipment, you
should get information on approved collection systems from our local representative.
By applying this European Directive you will improve the environment and human
health!