Kemppi Protig 501L - Manual (Page 29)

PROMIG 501, PROMIG 511/0537 – 29 © KEMPPI OY
6. Automatic remote -> local switching with MC, ML and
MX panel
7. Hot start function with MC and ML panel
No hot start, on delivery
Hot start selected
ML/MC-panel: No crater filling, on delivery
MX-panel selecto does not restore U-pot. value (fine control active)
2T MIG without panel
8 A. Crater filling in 4T with synergic MIG / PULSMIG, ML-panel only
8 B. Selection of 2T or 4T with ”no panel”
8 C. Selection of crater filling with MC panel
8 D. MX-panel selecto restores U-pot. value
9 A. Selection of synergic MIG / pulsed MIG, ML-panel
9 B. Selection of plate thickness / amperage display, MX-panel
Fe synergic PULSMIG / MIG in ML panel, on delivery
Plate thickness display is on with MX-panel
AlSi synergic PULSMIG / MIG in ML panel instead of Fe.
Extra label needed to change Fe text to AlSi text
Amperage display is on with MX-panel
10. Selection of max wire feed speed
Max. speed 18 m/min, on delivery
Max. speed 25 m/min
Remote -> local switching works, when remote controller is taken away
Remote -> local switching is off
ML-panel: Crater filling in 4T with synergic PULSMIG/MIG
MC-panel: Crater filling in 4T
MX-panel selecto restores U-pot. value (no fine control)
4T MIG without panel