Dukane 8776-W User Manual
Page 8
6
AC inlet (
15)
Power switch (
19)
Elevator button (
10)
COMPONENT
VIDEO ports (
14)
Y
C
B
/P
B
C
R
/P
R
S-VIDEO port (
14)
VIDEO port (
14)
CONTROL port (
13)
Elevator foot (
10)
Rear-Left side
Ports (See below.)
Vent
AUDIO OUT port
(
13)
AUDIO IN port (
13)
(In the default setting, the AUDIO
IN port is the audio port for
the RGB IN port, however, it is
possible to change the settings.
38)
AUDIO IN3 L/R port (
14)
(In the default setting, the
AUDIO IN3 L/R port is the audio
port for the VIDEO, S-VIDEO
and COMPONENT VIDEO
ports, however it is possible to
change the settings.
38)
RGB IN port (
13)
NOTE (*) About Restart switch: This projector is controlled by an internal
microprocessor. Under certain exceptional circumstances, the projector may not
operate correctly and the microprocessor will need to be reset. In such a case,
please push the Restart switch by using a cocktail stick or similar, and before
turning on again, make the projector cool down at least 0 minutes without
operating. Only push the Restart switch in these exceptional instances.
Restart switch (*) (
66)
Part names
USB port (
13)
CR/P
R
CB/P
B
AUDIO IN
2
AUDIO IN
1
RGB IN
1
RGB IN
2
SD CARD
AUX I/O
DC 5V
0.5A
LAN
CONTR
OL
RGB OUT
AUDIO OUT
USB
VIDEO
S-VIDEO
AC IN
Kensington lock slot
RGB OUT port (
13)
RGB IN port (
13)
AUDIO IN port (
13)
(In the default setting, the AUDIO IN port is the audio
port for the RGB IN port, however, it is possible to
change the settings.
38)
SD CARD slot (
13)
This slot is used when
utilizing SD CARD.
AUX I /O port (
13)
This port is used when
utilizing USB Memory.
LAN port (
13)
Used for Ethernet
input/output.
This port is used
when utilizing network
functions.
LAN
Y
R
L
AUDIO IN3
AUDIO IN1
AUDIO OUT
USB
RGB OUT
AUDIO IN2
VIDEO
S-VIDEO
C
B
/
P
B
C
R
/
P
R
CONTROL
RGB IN2
RGB IN1
K
AUX I/O
SD CARD
Ports