ikan TL2000HD-CO - Manual (Page 14)

21 10
Scaling seting
After entering the SCALING
interface, Turn the knob to select the
SCALING .Then press the knob
to enter the SCALING interface.
SCALING MODE CAN BE ADJUSTED ONLY BASED ON USER
Press the (BRIGHT) knob to enter the
main menu, turn the knob to select
SCALING ,Then press the knob
to enter the SCALING interface.
SDI
4:3
16:9
LETTER BOX
SDI
Turn the (BRIGHT) knob to select
the required item , then press the knob to confirm,
[V] will appear.
DEVICE SYSTEM DEFAULT IS AUTO
4:3
16:9 [V]
LETTER BOX
SDI
4:3
16:9
LETTER BOX
SDI
4:3
16:9
LETTER BOX Turn the (BRIGHT) knob to select the
USER item , press the knob to confirm.
TALLY connection
Always being on
Blink
INT A(High level) INT B Low level
Connecting the external TALLY signal with the plug DB-9,
shown as the map
1 5
6
½ Ó µ Ø
6
INT A
INT B
LOCK 4 3/16 9 SCALE VIDEO SDI1 HDMI
F BLUE ONLY B/W SCAN SDI2 VGA
PO WE R DC I N TA LL Y VG A DP DC O UT HD MI SD I OU T SD I1 I N SD I2 I N VO DE O O UT VO DE O I N AU DIO L AU DIO R
Enlarge
TALLY connection sketchmap
1.Judge the external TALLY signal level
2.Shown as the map , connecting the high(low) signal level with
INT A (PIN1) or INT B(PIN 4)
Low signal level
High signal level Green TALLY light
Red TALLY light
Active connection : external device is common-grounded with
the monitor
Refer to the next page for the Tally light mode choosing