English – DeWalt DW706 User Manual

Page 7

English

FIG. 2

GUARD

RIGHT SIDE

FENCE

MITER

CLAMP

KNOB

MITER

LATCH

MITER

SCALE

BENCH MOUNTING

HOLES

LEFT SIDE FENCE

CLAMPING KNOB

LOCK DOWN

OPERATING HANDLE

BEVEL SCALE

FIG. 4

TRIGGER

SWITCH

OPERATING

HANDLE

LEFT SIDE

FENCE

MOTOR

HOUSING

45˚ BEVEL

OVERRIDE

LEVERS

DUST

SPOUT

MOTOR END

CAP

0˚ BEVEL

OVERRIDE

KNOB

LOCK DOWN

BEVEL STOP–

33.85˚ PAWLS

CARRY HANDLE

BLADE

WRENCH

45˚

BEVEL STOP–

ADJUSTMENT

SCREW

BEVEL

LOCK

KNOB

HAND

INDENTATIONS

0˚ BEVEL STOP

ADJ. SCREW

(25.4mm) diameter blade hole] and against the inner
clamp washer with the teeth at the bottom of the blade
pointing toward the back of the saw.

3. Assemble the outer clamp washer onto the spindle.
4. Install the blade screw and, engaging the spindle lock,

tighten the screw firmly with wrench provided. (Turn
counterclockwise, left-hand threads)

NOTE: When using blades with a 5/8" (15.88mm) diameter
blade hole, the blade adapter will not be used and should be
stored in a safe place for future use.

5. Return the guard bracket to its original position and

firmly tighten the guard bracket screw to hold bracket in
place.

WARNING:

• The guard bracket must be returned to

its original position and the screw tight-
ened before activating the saw.

• Failure to do so may allow the guard to

contact the spinning saw blade result-
ing in damage to the saw and severe
personal injury.

Transporting the Saw

TURN OFF AND UNPLUG THE MITER SAW BEFORE
ATTEMPTING TO MOVE IT OR MAKE ANY ADJUST-
MENTS WHAT SO EVER!

In order to conveniently carry the miter saw from place to
place, a carrying handle has been included on the top of the
saw arm and hand indentations in the base, as shown in
Figure 4.