Sizing, Parts list battcars, Luff cars – Harken 1782 System C Battcars: built before 2008 User Manual
Page 2: Mounting kit, End kit, Flat battslide, One required for each track, One required for each system. headboard assembly
1816 Track: 6’9
15
/
16
" (2.08 m) long track.
Number of sections will vary according
to luff length.
Make sure you have the correct size
track. System C track is 1
1
/
4
" (32 mm)
wide.
Track for Drilling and Tapping
516/758/1847 Track: You must use
516/758/1847 track for drilling and
tapping. Use
5
/
16
" (8 mm) FH screws,
not included.
Do not use 1816 open backed track for
drilling and tapping the mast. This track
must have the support of the mounting
slugs.
See page 8 for mounting instructions.
2
Sizing
Make sure that you have the
correct size Battcar system
for your boat.
Maximum Sail Area
System
Monohull
Multihull
Maximum
Boat Length
1400 ft
2
130 m
2
1200 ft
2
111 m
2
80’
24 m
C
Parts List
BATTCARS
Flat Battslide
®
fitting with
threaded post is shown. You
may have toggle attachment,
round batten ends or SDA
batten fittings (not included).
LUFF CARS
Luff cars not required
if battens are close
enough to support sail.
Plastic spacers go
to sailmaker
MOUNTING KIT
One required for each track.
END KIT
One required for each system.
HEADBOARD ASSEMBLY
2 - Headboard Cars
1 - Coupler
7 - 19 mm Rings
19 - Mounting Slugs
1” (25 mm)
1 - Connector Slug
4
1
/
8
" (105 mm)
2 - Tubes
Blue Loctite
®
21 - Flathead Screws
8 mm x 25 mm (1")
2 - End Stop Slugs
2" (51 mm)
4 - Flat Head Screws
8 mm x 40 mm (1
9
/
16
")
2 - End Stops
1 - Tube
Blue Loctite
®
3
/
4
”
(19 mm)
1
1
/
4
” (32 mm)
1
1
/
4
” (32 mm)
2 - Headboard Plates
2 - Tubes Blue Loctite
®
1 - Batten Receptacle
1 - Battcar
6 - Screws
6 - Barrel Nuts
Sail Spacers