Harken 1825 Battcar with SDA fitting - Manual (Page 2)

Printed in USA 4541 11/13
For additional safety, maintenance and warranty information see www.harken.com/manuals or the Harken ® catalog.
Maintenance
Warranty
Inspect
Frequently inspect shackles and control block fittings for signs of fatigue and replace as necessary. Make sure every
installation includes Harken track end stops. Arrange control tackle so cars do not hit end stops under load.
Traveler Cars: Clean by frequently flushing with fresh water. Periodically clean car by squirting a detergent/
water solution into center openings. Roll car back and forth to distribute evenly then flush bearings with
fresh water.
Do not use spray lubricants because ball bearings may skid not roll. Apply one to two drops of McLube
®
OneDrop ™ to ball contact surfaces of track. Roll car back and forth through OneDrop ™ several times
to distribute onto bearings. Wipe remaining OneDrop ™ off track. OneDrop ™ is preferred but you can
also use one to two drops of a light machine oil. Too much oil attracts dirt.
Track: Clean with detergent and water.
Important! Exposure to some teak cleaners and other caustic solutions can result in discoloration of part and is
not covered under the Harken warranty.
Printed in USA 4541 11/13
For additional safety, maintenance and warranty information see www.harken.com/manuals or the Harken ® catalog.
Maintenance
Warranty
Inspect
Frequently inspect shackles and control block fittings for signs of fatigue and replace as necessary. Make sure every
installation includes Harken track end stops. Arrange control tackle so cars do not hit end stops under load.
Traveler Cars: Clean by frequently flushing with fresh water. Periodically clean car by squirting a detergent/
water solution into center openings. Roll car back and forth to distribute evenly then flush bearings with
fresh water.
Do not use spray lubricants because ball bearings may skid not roll. Apply one to two drops of McLube
®
OneDrop ™ to ball contact surfaces of track. Roll car back and forth through OneDrop ™ several times
to distribute onto bearings. Wipe remaining OneDrop ™ off track. OneDrop ™ is preferred but you can
also use one to two drops of a light machine oil. Too much oil attracts dirt.
Track: Clean with detergent and water.
Important! Exposure to some teak cleaners and other caustic solutions can result in discoloration of part and is
not covered under the Harken warranty.