Harken 2234 Bosun's Chair - Manual (Page 4)

4 Bosun's Chair — General 03/11/13
GENERAL Inspection
Service
A competent person must inspect equipment frequently, at least every
12 months, and always before use.
Ensure product markings are still legible.
If wear or damage is detected, return to manufacturer for repair or replacement.
Any attempt to modify or repair equipment by user will void the warranty.
WARNING! Modifying, changing, or temporarily securing the
equipment to “get the job done” could lead to a fall.
If chair has been subjected to a severe shock load, it must be removed
from service and replaced.
WARNING! A chair that has been subjected to a shock load
can be severely weakened and subject to further deterioration
through normal use. Do not use the chair after a shock load.
Failure to replace such a chair may result in the chair breaking,
leading to a fall.
Inspect Weld
Before using for first time, perform a comfort and adjustability test in a safe
place to ensure chair is correct size, has sufficient adjustment, and
has acceptable comfort level for intended use.
Weight should be centered on seat. Crotch strap must be used. Legs
must be on either side of crotch strap.
WARNING! Failure to use crotch strap can result in user slipping
out of chair and falling. Always use the crotch strap.
Adjust webbing buckles on back support and waist strap to ensure a snug,
comfortable fit.
Ensure locking tabs on waist buckle are fully snapped into place.
Ensure steel triangle attachment points are clear of clothing, and to front of body.
CORRECT
Chair Fit
INCORRECT
Waist strap inserted through crotch strap. Waist strap must be inserted through crotch
strap before it is fastened.
Waist Strap
Crotch Strap