beautypg.com

Terminating loop outside block or using lashing – Harken 3195 Black Magic Loop Blocks pre-2013 User Manual

Page 3

background image

9. Lash loop to head of

block with small control

line using a Carrick bend or

a square knot and run tail

up behind wrap, then down,

and under itself on each side

of knot. Pull tight to secure.

For knot tying resources see

www.harken.com/knots.

Terminating Loop Outside Block or Using Lashing

1. Use allen wrench

to remove screw.

If terminating line outside block or lashing using multiple strands

of smaller-diameter line you must remove the dead-end post.

2. Remove dead-end post.

If lashing comes loose block

can flip so that sheet rides

off sheave.

Dead-end post

10. Further secure stop knot

by carefully melting line

ends with a hot knife.

3. Re-assemble block. Use

blue Loctite

®

on screw.

5. Secure stop knot by

carefully melting line

ends with a hot knife.

4. Lash loop to head of

block with small control

line using square knot. Run

line ends up and behind

lashing, then down and

under itself on each side

of knot. Pull tight to secure.

WARNING! If lashing comes loose, block can flip and cause line

to jam, resulting in loss of control. Inspect lashing often and

redo if necessary.

WARNING! Attaching line to block head will considerably weaken

block so it can easily break under load. Attach loop/lashing only

through mouth of sheave.

Do not attach

to head