Harken 2608 40 mm Ratchet Block - Manual (Page 3)

Parts — 40 mm Carbo Ratchets
2608/2609 40 mm Single Ratchet
No. Description Qty Part No.
1 Shackle Assembly Micro 5 / 32 " 246
A Shackle Strap 1 HSB104
B Shackle Clevis Pin 5 / 32 X .488 1 HSB105
C Split Ring 1 HSB24
2610/2611 40 mm Single Ratchet
w/471 Carbo Cam
1 Screw M3X30 Slotted Panhead 1 HFS888
2 Washer Cam Arm Left 1 H-26265B
3 Washer Cam Arm Right 1 H-27031B
4 Nut M3 1 HFS939
5 Cam Arm Left 1 H-46865
6 Cam Arm Right 1 H-46866
7 Nut M4 2 HFS890
8 Cam Cleat Micro Carbo 1 471
9 Micro Flairlead Black 1 424B
10 Cam Screws M4X30 Slotted
Panhead
2 HFS889
11 Cam Plate for Reversing Cam 1 H-27034B
12 Shackle Assembly Micro 5/32” 246
A Shackle Strap 1 HSB104
B Shackle Clevis Pin 5 / 32 X .488 1 HSB105
C Split Ring 1 HSB24
2
1
4
5
6
7
8
9
10
11
12
B
A
C
Right-angle reeving dead-end on becket
For larger, printable diagrams, please see: www.harken.com.
1
2
3
4
5
6
6:1 Right-Angle Reeving
Dead-end on cam
6:1 Right-Angle Reeving
Dead-end on becket
6
2
3
4
5
6
6
1
6:1
Reeving Multi-Purchase Systems
1
A
C
B
Part No.
HFS889
1 2
Adjust Cam Angle (Single/40 mm) Reverse Cam Cleat (Single Only)
1. Remove screws from cam.
2. Assemble as shown. Note: use plastic plate on cam
bottom.
3. Tighten screws. Do not overtighten screws.
Cam pawls should snap shut smartly.
1. Loosen cam arm locking plate screw and pull outward
to disengage.
2. Rotate cam arm to desired position.
3. Press locking plate in and tighten screw. Avoid
binding sheave, do not over-tighten screw.
5:1 Right-Angle Reeving
Dead-end on Becket
1
2
3
4
5
5
5:1 8:1
1
2
3
5
6
7
8
4
1. Remove three cam arm screws on each side.
2. Carefully note position of three screw holes in
block (see diagram).
2. Rotate cam arm to desired position and line
up cam arm holes with screw holes on block.
3. Insert screws into screw holes and tighten.
Do not overtighten screws or sheave will bind.
Adjusting Cam Angle 57 mm (Single/Triple/Fiddle), 75 mm (Fiddle)
1
2
3
4
5
6
6:1 Right-Angle Reeving
Dead-end on cam
6:1 Right-Angle Reeving
Dead-end on becket
6
2
3
4
5
6
6
1
6:1
Right-angle reeving
dead-end on cam