2606 cheek block – Harken 2600 57 mm Shackle & Cheek Block User Manual
Page 2

2606 Cheek Block
Using block as template, mark holes using a centerpunch. Remove block and
drill holes using a
13
/
64
" (5.2 mm) drill. Bevel top of deck holes using a small
knife to allow sealant to mass. Through-bolt block using recommended
stainless steel fasteners, washers and locknuts.
3-Way U-Lock—2602 / 2603 / 2604 / 2605 / 2617 / 2618 / 2629 / 2631
Part
No.
Fasteners
A
B
in
mm
in
mm
2606 M5 or #10 PH/RH* 1
7
/
8
47
1
/
2
12
*Fastener length: Add deck thickness and overhang for nut
and washer.
A
B
Part No.
HFS889
1
2
Adjust Cam Angle (Single/Triple)
Reverse Cam Cleat (Single Only)
1. Remove screws from cam.
2. Assemble as shown. Note: use
plastic plate on cam bottom.
3. Tighten screws. Do not
overtighten screws. Cam
pawls should snap shut smartly.
1. Loosen cam arm locking plate screw and
pull outward to disengage.
2. Rotate cam arm to desired position.
3. Press locking plate in and tighten screw.
Avoid binding
sheave, do
not over-
tighten
screw.
3-Way Cam-Lock—2600 / 2601 / 2615 / 2616 / 2621 - 2624
The 3-Way U-Lock on doubles and triples allows a change
of headpost direction from front to side or allows the
block to swivel. To change headpost direction, remove
shackle, turn post, install shackle. Remove U-Lock to
allow block to swivel.
1
1. Cam lever up.
Block locks in
front or side
position.
2. Cam lever down.
Block turns
freely.
2
- 2601 57 mm Shackle & Cheek Block 2602 57 mm Shackle & Cheek Block 2603 57 mm Shackle & Cheek Block 2604 57 mm Shackle & Cheek Block 2605 57 mm Shackle & Cheek Block 2606 57 mm Shackle & Cheek Block 2615 57 mm Shackle & Cheek Block 2616 57 mm Shackle & Cheek Block 2617 57 mm Shackle & Cheek Block 2618 57 mm Shackle & Cheek Block 2631 57 mm Shackle & Cheek Block