Harken 351 29, 40, 57 mm Ti-Lite Block - Manual (Page 2)

C6
C5 Slide crossed lines
onto end of boom.
See: E Finish—
Dead-End Line.
D2 Follow instructions
A, B, C or D to attach
to bail, post or boom.
See: E Finish—
Dead-End Line.
E3 Tie a loose figure
eight knot. Move knot
so it is tight against
block. Leave at least
25mm (1") of line
beyond knot. Repeat
for other line end.
Trim excess line.
C3
C4
C5
C7 C8
E1
E3
E Finish—Dead-End Line
D Add Becket
C Tie to Boom—Large Diameter Object
C2
D1
D2
C1
C7 Once tied, block can be rotated to either
a parallel or perpendicular position (C8).
MOUTh
C1 Pass line through
mouth, through head
and around boom so
line crosses as shown.
C2 Repeat C1.
Cross lines.
C3 Repeat C1.
Cross lines.
See: E Finish—
Dead-End Line.
C4 If you have access
to end of boom, make
three loops as shown.
Cross each loop
separately as shown.
C6 IMPORTANT!
You must use crossed
lines when tying to
a large diameter so
head of block is
not damaged.
D1 Pass line through
mouth to make two
becket loops.
E1 Cinch block to
desired tension.
Printed in USA 4927/03-10
Harken ® equipment is designed for minimal maintenance, but some
maintenance is required for optimum and safest possible operation
and to comply with the Harken limited warranty.
In general, the most important aspect of maintenance is to keep your
equipment clean by frequently flushing with fresh water.
Maintenance
Warranty
For additional safety, maintenance and warranty information see
www.harken.com or the Harken ® catalog.
E2
E2 Start with line
coming out of mouth,
pass it through small
dead-end hole. On
2607 (57mm) pass
line from mouth
through outer hole
at side of rivet then
through inner hole.
MOUTh
CORRECT
INCORRECT
INCORRECT