Harken 2148 T2 Loop Block - Manual (Page 3)

Inspect loop for chafe or UV-damage every time you sail.
Replace damaged loop immediately. Replace line with
no visible damage every two-years use.
Inspect Line Every Time You Sail
WARNING! Failure to inspect and replace UV-damaged, worn or frayed line can cause
the line to break suddenly, possibly causing an accident, damage to your vessel, personal
injury or death. See www.harken.com for additional safety information.
Use Harken supplied loops. Refer to specification chart. If you make your own loops refer to Using
Alternate Line Knots and Splices on last page.
Assembly
Remove one end of loop.
Tip: Use a small hooked tool or allen wrench to lift loop off the anchor post. Slip loop around bail.
Run loop into head at bottom of block and into mouth as shown.
Tip: use a tool to push loop into mouth.
Secure end of loop to Anchor Post. Pull on block to make sure loop is seated.