Grandstream GXP21xx Series User Manual - Manual (Page 61)

FIRMWARE VERSION 1.0.8.4 GXP2120/GXP2110/GXP2100/GXP14xx USER MANUAL Page 59 of 85
mask. #XX or #X are also valid so leading 0 is not required (but OK). No
SIP server is required to make quick IP call. The default setting is "No".
Disable Conference Disables the Conference function. The default setting is "No".
Disable in-call DTMF Display
When it's set to "Yes", the DTMF digits entered during the call will not
display. The default setting is "No".
Enable sending DTMF via
Speed Dial Enables Multi Purpose Key to send DTMF during the call (Not applicable
to GXP14xx). The default setting is "No".
Disable DND Button
If set to "Yes", the DND button will not set the phone to DND. The default
setting is "No".
Disable Transfer Disables the Transfer function. The default setting is "No".
Enable Idle Mute
If this feature is enabled, MUTE key will take effect in idle state and future
incoming call will be answered with mute.
In-call dial number on pressing
transfer key Configures the number for the phone to dial as DTMF during the call
using TRAN button.
Auto-Attended Transfer
If set to "Yes", the phone will use attended transfer by default. The default
setting is "No".
Do Not Escape # as %23 in
SIP URI Specifies whether to replace # by %23 or not for some special situations.
The default setting is "No".
Click-To-Dial Feature Enables Click-To-Dial feature. The default setting is "Disabled".
Blink message LED on
ringing(for GXP140x only)
Message LED light will blink if there is an incoming call.
Call History Flash Writing:
Write Timeout Defines the interval (in seconds) to save the call history to phone's flash.
The default value is 300 seconds.
Call History Flash Writing:
Max Unsaved Log Defines the number of unsaved logs before written to phone's flash. The
default value is 200 entries.
Settings -> Multicast Paging
Paging Barge
During active call if incoming multicast page is higher priority than this
value the call will be held and multicast page will be played. Note: 1 is the
highest value.
Paging Priority Active
If enabled, during a multicast page if another rmulticast is received with
higher priority, that one will be played instead. Note: 1 is the highest
value.
Multicast Paging Codec The codec for sending multicast pages.
Multicast Listening Defines multicast listening addresses and labels.
Settings -> Ring Tone
Call Progresses Tones: Configures ring or tone frequencies based on parameters from local