GAI-Tronics MS05-101 Desktop Master Station consisting of Subset, Amplifier and Enclosure - Manual (Page 9)

Pub. MS05-101iom.2
Model MS05-101 Desktop Master Station Page: 9 of 11
\\86h27g1-fs\iomdocs\opnotes -- released\mi05-00x merge-isolate cabs\ms05-101.dir\ms05-101iom2.doc
03/09
Lamp Test/ Reset
Momentarily press the red push button located on the back of the Model MS05-101 Master Station. All
LEDs should momentarily illuminate. This action also resets the I/O controller.
Optional Features
These options are available only when the applicable kits are installed in the merge/isolate cabinet.
Depending on the merge/isolate cabinet installed in the system, not all the features may be available.
Activating an Alarm
N OTE : This feature is only available if a Model 10959-101 or 10959-104 Audio Messenger Interface is
connected to the system merge/isolate cabinet.
Alarms can be automatically broadcast to all zones when activated (automatic), or can be manually routed
to broadcast to any combination of zones or all zones (selective).
For selective alarm routing, complete the following steps to activate an alarm from a master station:
1. Select the desired alarm destination using the Z ONE S ELECT push buttons (1 through 5 or A LL ). The
destination could be a single zone, a group of zones, or all zones. The green LED indicators for the
selected zones illuminate.
2. Press the MERGE push button.
3. Select the appropriate ALARM push button (1 through 7).
The alarm is broadcast into the selected zones and from the master station speaker. The red LED
indicator for the selected alarm switch illuminates during the broadcast.
4. To cancel an alarm, press the A LARM RESET push button.
N OTE : The zones remain merged. To isolate the zones, press the MERGE push button again
followed by the Z ONE S ELECT RESET push button.
For automatic alarm routing to all zones, complete the following steps to activate an alarm from a master
station:
1. Select the appropriate ALARM push button (1 through 7).
The alarm broadcasts into the all zones and from the master station speaker. The red LED indicator
for the selected alarm switch illuminates during the broadcast.
2. To cancel an alarm, press the A LARM RESET push button.
N OTE : The zones remain merged. To isolate the zones, press the Z ONE S ELECT RESET push
button.