GAI-Tronics CommandPLUS Series Desktop Console Installation and Service Manual - Manual (Page 32)

Console Diagnostics CommandPLUS Series Desktop Console Installation and Service Manual
12/10 28
Printer Error Messages
The console supports the use of a serial printer to log decoded ANI information as well as access to
diagnostics and other diagnostic data. If the printer is enabled through the CARD Suite software and the
console detects an error, PRINTER ERROR is displayed on the lower right-hand side of the console
display unless the printer error message is disabled. This is useful to detect when the printer has lost
power or is out of paper.
To disable or enable the printer error, enter the printer error screen. The console displays the current
setting as shown below.
USER PARAMETERS
1) SIDE TONE VOLUME ADJUST
2) MIC SELECTION/LEVEL ADJUST
3) PRINTER ERROR: ON (1=ON, 2=OFF)
TO EXIT
12:22:19PM VU
MAY-12-07
Figure 10. Printer Error
Clock and Display Set
The clock and display can be modified. When this option is selected, the following display is shown.
CLOCK AND DISPLAY SET
1) SET CLOCK AND DATE
2) SET DISPLAY VIEWING ANGLE
3) SET DISPLAY BRIGHTNESS
<1-3> SELECT
TO EXIT
12:22:19PM VU
MAY-12-07
Figure 11. Clock and Display Set Menu