GAI-Tronics CommandPLUS Series Desktop Console Installation and Service Manual - Manual (Page 19)

CommandPLUS Series Desktop Console Installation and Service Manual Installation
15 12/10
Installation
The electrical hook-up of the console requires these basic connections: the ground wire, one to three
channel interface cables, and the power supply cable.
WARNING
Voltages hazardous to life may be present at the exposed control line terminals under certain conditions
during the following procedures. These voltages are also present on some component leads. Care should
be taken to avoid shock during installation.
Electrical Interface
All of the electrical connections to the console are made at the rear panel. Power to the console is
furnished through a 5-pin, DIN connector, P5. The Figure 2 shows the rear view of the CommandPLUS
Series Desktop Console and the locations of the various connectors.
The pinout for the power DIN connector is shown in Table 4:
Table 4. Power DIN Connector Pinout
Pins Function
1, 4 B-, Batt-, GND tab
3, 5 B+, IN
2 Batt+
OUTPUT
LOGGING
CHANNELS 1-4
MIC
HANDSET
HEADSET
RS232 CONNECTOR FOOT
SWITCH
TELEPHONE
INTERFACE
CHANNELS 9-12
RESET LED
STATUS
POWER
CHANNELS 5-8
Figure 2. View of CommandPLUS Back Panel with Connectors
5 4
2
3 1
Figure 3. Power Connector Pinout