FSR MAS-3200 - Manual (Page 9)

MAS-3200 9
CONNECTING THE HARDWARE
The first step is to connect a video source to the input of the MAS-3200 and to connect its
output to a display device. Below is a photograph of the rear panel of the unit.
Connecting the Video Inputs
The Video Scaler can accept a Composite Video, or S-Video input signal for scaling, as well as a computer
signal input that can be passed through.
• Composite Video - use a BNC cable to connect the Composite Video output of the source equipment to
the connector labeled “VIDEO” on the back of the unit.
• S-Video - use an S-Video cable to connect the S-Video output of the source video equipment to the
connector labeled “S-VIDEO” on the back of the unit. S-Video provides improved performance over
Composite Video and is recommended whenever possible.
• PC Video - connect the source computer’s VGA output signal to the HD15 connector labeled “PC IN”
on the back of the unit. Note – This PC Input Signal is not scaled, but is available for pass-through when
the PC Source is selected.
Connecting the Video Output
Connect the MAS-3200's output to the destination display device, such as an LCD computer monitor,
video projector, HDTV Set or other device, via the HD15 connector on the back labeled “OUTPUT”.
Connecting Power to the Unit
The SC-1250 can accept 100-240VAC@50-60Hz. When the unit’s front panel Power
Switch is turned On, the Power LED indicator on the front will illuminate.