FSR MAS-3200 - Manual (Page 23)

MAS-3200 23
9 TROUBLESHOOTING
If the recommended actions listed below do not result in satisfactory operation, please consult the FSR
Technical Support Department or your equipment Dealer.
Problem and Possible Solution
No picture on the output monitor
If the LED is illuminated, check that there is a correct Video Input signal and that the display device
connected to the output is switched on and set to the correct input and its Brightness and Contrast are set
correctly.
Colors appear wrong on the output monitor
Try adjusting the Color, Tint, Contrast and Brightness settings on your display. These are usually set up for
viewing computer images, which may be somewhat different from viewing images that have
beenupconverted from video. Make sure your output cable assembly is not faulty, which could prevent
either the Red, Green or Blue signal from being passed through the cable.
Too much smearing
Smearing usually occurs when a Composite Video input is used and is generally unavoidable, unless you can
switch to using S-Video. Using good quality video cable will help towards reducing this affect.
Smearing that may not be noticeable on a small video monitor may become objectionable on a large screen
video projector.
No color on the output monitor, only a black and white image
Check the condition of the cables being used. A faulty S-Video cable can often cause a black and white
image. Ensure that the color controls on your computer monitor or video projector are all set correctly.
Ensure that the color adjustment on the Video Scaler is not adjusted completely down. It may be necessary
to reset the video levels by pressing the + and – Buttons simultaneously.