FSR MAS-3200 - Manual (Page 10)

10 MAS-3200
FRONT PANEL CONTROL
The MAS-3200 is controlled via Front Panel Buttons and status is indicated by the OSD (on screen
display).
Mode Button
Press the Mode Button repeatedly to toggle through the following controls, as shown on the OSD (On
Screen Display) of the video display connected to the output of the unit.
• Source Mode: While in this mode, press the + or – Button to choose the desired input source from:
Video, S-Video or Component Video.
• Resolution Mode: If the output is selected as RGB, press + or – Button to choose the output resolution
from: VGA, SVGA, XGA or SXGA for PC output.
• Output Mode: Press + or – Button to select either PC (RGB) or HDTV (YPbPr) out.
• Aspect Mode: Press + or – Button to choose between Standard Aspect (4:3) and Wide Aspect (16:9)
output.
• Enhancement: Turn the 3D Comb Filter function On or Off by with the + and - Buttons. Note – When
VCR or non-standard video source is connected to the input, the output picture may jitter. If this occurs,
please turn off the 3D Enhance function.
• Digital NR Mode: Turn the Digital Noise Reduction function On or Off by using the + and – Buttons.
Picture Button
Press the Picture Button repeatedly to toggle through the following picture adjustment
parameters, then use the + and – Buttons to adjust the level.
• Contrast: The range of this adjustment is 0~48. The Factory Default is 40.
• Bright: The range of this adjustment is 0~48. The Factory Default is 24.
• Saturation: The range of this adjustment is 0~48. The Factory Default is 24.
• Hue: (NTSC Only) The range of this adjustment is 0~48. The Factory Default is 24.
• Detail: The range of this adjustment is 0~48. The Factory Default is 10.
Input Button
Press the Input Button to toggle through the input sources.
+ and - Buttons
Press these buttons for control or to set values as described above.