FSR HD-HPC-SP-Tx - Manual (Page 17)

17
RS-232 Control and Firmware Updates
The RS-232 port can be used as pass-through to control a device connected to
the Transmitter from the Receiver or vice versa. In addition, the RS-232 port on
the Transmitter or Receiver can be connected to a computer to update the
firmware. (See Dip switch settings)
Scenario 1: Firmware Update
Scenario 2: RS-232 Control
Maximum Baud rate is 115.2 Kbps.
+
-
DC 12V
- + LOCAL OUT HDMI IN Tx Rx IR IN IR OUT VGA IN L / R
HD-H-SP-Rx shown (ordered seperately)
NORMAL
UPDATE
HDMI OUT Tx Rx IR OUT IR IN +
-
DC 12V
- +
Set switch to NORMAL
Set switch to NORMAL
HDBaseT
RS-232 DEVICE
RS-232 DEVICE
+
-
DC 12V
- + LOCAL OUT HDMI IN Tx Rx IR IN IR OUT VGA IN L / R