FSR HD-HPC-SP-Tx - Manual (Page 10)

10
ID Name Description
8 ETHERNET Connects to an Ethernet device
9 VGA IN Connects to a VGA source
10 Audio IN Audio input, embedded stereo in VGA audio
Hardware Installation
Warnings
 Before the installation, disconnect the power supply from all the
devices.
 Do not connect or disconnect cables from the Transmitter and
Receiver while they are powered ON. To connect or disconnect
cables from the units, power them OFF first.
 For best resolution and ESD performance Shielded CAT6A in a TIA
/ EIA 568B wiring configuration is recommended. Please use care
when installing, connecting and disconnecting cables.
1. Connect the source to the HDMI IN on the Transmitter.
2. Connect the IR emitter to the IR OUT and the IR Receiver to the IR IN on
both the Transmitter and Receiver.
3. Connect a Display to the HDMI OUT on the Receiver.
4. Connect the HDBT OUT on the Transmitter to the HDBT IN on the Receiver
via a shielded CAT5e / CAT6 / CAT6A / CAT7 cable.
5. Connect the power supply to either the Transmitter or Receiver.