FSR DV-WPHXT-1C-WHT - Manual (Page 13)

13
EDID data saving setup
Follow this setup procedure to auto acquire the EDID data when the rotary
switch setup under Step 4 of the preceding “Video Connection” setup is
unsuccessful or the correct EDID data for the display can not be found on the
Internal (Pre-saved) EDID table.
Step 1:
Connect VGA or DVI / HDMI source input port on DV-WPHXT-1ctx
directly to the display.
Step 2:
Power up the display and DV-WPHXT-1ctx.
Step 3:
Select the appropriate source input port; VGA or DVI / HDMI
Step 4:
Set the number to “0” on the rotary switch.
Step 5:
Press the EDID Learn Button for 2~4 seconds.
Step 6:
Green Status LED will be illuminated (steady) for about 2-3 second if
the EDID was saved correctly.
Troubleshooting:

If the EDID was not saved correctly, the Green Status LED will
blink In this case, go back to Step 4

The EDID learn Button must be pressed after selecting one
of EDID data values using the rotary switch

Confirm that the EDID value was saved to the correct source
port such as VGA or DVI / HDMI (see step 3)
When changing EDID mode, unplug the power cable at the Transmitter.
Whenever you use HDMI embedded audio, you should set the EDID to “D”
which is 1080p@60hz, 2ch audio