Q-See QSEE H264 - Manual (Page 27)

52 53
Time Tab
You can set the length of time the DVRs record an event before and after a motion detection
or alarm is triggered as well as how long an individual record is preserved.
PICTURE 4-15
PICTURE 4-16
Pre-alarm record time: This sets the length
of time showing events prior to a
motion detection or sensor-triggered
event that is included in the record.
Post-alarm record: Sets the length of time -
from 10 to 60 seconds - that is
added to the record after the event is
finished.
Expire time: The time - up to 60 days - that
an event is saved on the drive before
it could be overwritten (See Recycle
Record below).
You can set up all channels with same values by selecting All and then configuring one
channel.
Stamp Tab
Select which cameras will display their ID and date stamp and where it’ll appear on the screen.
Drag and drop the location of the camera
name and date/time stamp to your desired
location on the screen. This can be done
individually or globally. A “Before” and “After”
example is shown below.
Snap Tab
In this tab, you can configure how many still images are taken, the quality of the images and
the timing between them when the Snapshot button is pushed on the Control Bar.
PICTURE 4-17
PICTURE 4-18
Enable Enable Snap Snap Record Bitrate Record Bitrate Recycle Record Recycle Record Time Time Stamp Stamp
RECORD RECORD
Default Default Apply Apply Exit Exit
Resolution
Quality
Snap Time Interval [S]
Snap Number
Resolution
Quality
Snap Time Interval [S]
Snap Number
CIF CIF
Medium Medium
2 2
1 1
Recycle Record Tab
This is selected by default. Recycle record allows the DVR to record over old events when
the hard drive is full. Otherwise, the DVR will stop recording when there is no more space
available.