Fronius Agilo 75.0 - Manual (Page 42)

40
6 - Push the PE terminal up and over the
grounding terminal and the bare end of
the cable
- Tighten the PE terminal:
5 mm Allen key
Tightening torque = 12 Nm
7 - Place the AC cable in the clamp of the
strain-relief device
- Attach the clamps of the strain-relief
device to the rail
- Secure the AC cable with the clamps of
the strain-relief device
e.g.:
A cable routed at an angle from the
bottom right - attach the clamp for
the strain-relief device to positions
3 and 4
B cable routed at an angle from the
bottom left - attach the clamp for the
strain-relief device to positions 1
and 2
C vertical cable routing - attach the
clamp for the strain-relief device to
positions 5 and 6
Connecting AC
cables with a ca-
ble lug Alternatively, an AC cable with a cable lug can be connected to the M10 threaded bolts on
the mains connections in order to connect the AC cables to the V-type terminals.
6
7
NOTE! Different openings are available on the rail for attaching the clamps of the
strain-relief device, depending on the cable routing.
1
A B
C
2
4
6 3 5