Foxconn 6627MA-RS2H User Manual
Page 19
Chapter 2 Installation Instructions
12
Other Connectors
This motherboard includes connectors for floppy devices, IDE devices, Serial
ATA devices, USB devices, IR module and others.
FDD Connector: FLOPPY
This motherboard includes a standard FDD connector, supporting 360K, 720K,
1.2M, 1.44M, and 2.88M FDDs.
IDE Connectors: PIDE & SIDE
These connectors support the provided Ultra DMA 133/100/66 IDE hard disk
r i b b o n c a b le . C o n n e c t t h e c a b le
’ s b lu e c o n n ec to r to th e p r im a ry
(recommended) or secondary IDE connector, then connect the gray connec-
tor to the Ultra DMA 133/100/66 slave device (hard disk drive) and the black
connector to the Ultra DMA 133/100/66 master device. If you install two hard
disks, you must configure the second drive as a slave device by setting its
jumper accordingly. Refer to th e hard disk do cumen tation fo r the jumper
settin gs.
Attention:
Ribb on cab les are directional, therefore, make sure to always
connect with the cable on the same side as pin 1 of the PIDE/SIDE
or FDD connector on the motherboard.
Audio Connectors: CD_IN, AUX_IN
CD_IN and AUX_IN are Sony standard CD audio connectors, they can be con-
nected to a CD-ROM driver through a CD audio cable.
CD_IN
1
CD_L
GND
CD_R
AUX_IN
1
AUX_L
GND
AUX_R
PDF 文件使用 "pdfFactory" 试用版本创建