Foxconn BLACKOPS User Manual
Page 55
48
3
Memory Timing Config
► ECC Scrubbing
ECC Scrub is basically ECC with one additional characteristic, it completely refreshes the
memory after each correction. This item is used to enable/disable ECC Scrubbing feature.
► DRAM Timing Selectable
This item is used to enable/disable provision of DRAM timing by SPD device. The Serial
Presence Detect (SPD) device is a small EEPROM chip, mounted on a DDR3 memory
module. It contains important information about the module's speed, si�e, addressing mode
and various other parameters, so that the motherboard memory controller (chipset) can better
access the memory.
► CAS Latency Time (tCL)
This item controls the CAS latency, which determines the timing delay (in clock cycles) before
SDRAM starts a read command after receiving it.
► RAS# to CAS# Delay (tRCD)
This item allows you to select a delay time (in clock cycles) between the CAS and RAS strobe
signals.
► RAS# Precharge (tRP)
This item allows you to select the DRAM RAS precharge time (in clock cycles).
► Precharge Delay (tRAS)
This item allows you to set the precharge delay time (in clock cycles).
► Row Refresh Cycle (tRFC)
This item allows you to set Row Refresh Cycle (in clock cycles).
► Performance Level
This item allows you to set the performance level for your memory.
► Write to Precharge (tWR)
This item allows you to set Write to Precharge delay (in clock cycles).
► Write to Read Delay (tWTR)
This item allows you to set minimum Write-to-read delay (in clock cycles).
► Act to Act Delay (tRRD)
This item allows you to set Act to Act Delay (in clock cycles).
Phoenix - AwardBIOS CMOS Setup Utility
Memory Timing Config
ECC Scrubbing
Disabled
Item Help
DRAM Timing Selectable
By SPD
CAS Latency Time (tCL)
Auto
Menu Level ►
RAS# to CAS# Delay (tRCD) Auto
RAS# Precharge (tRP)
Auto
Precharge Delay (tRAS)
Auto
Row Refresh Cycle(tRFC)
Auto
Performance Level
Auto
Performance Level
Auto
Write to Precharge(tWR)
Auto
Write to Precharge(tWR)
Auto
Write to Read Delay(tWTR)
Auto
Act to Act Delay(tRRD)
Auto
Read to Precharge(tRTP)
Auto
All Precharge to Refresh
Auto
Refresh Period Ratio
x 1
Refresh Period(tREF)
Auto
Command Per Clock
Auto
Per Clock
Auto
Auto
Read Delay Phase(tRD)
Auto
↑↓��������:Move Enter:Select +/-/PU/PD:Value F10:Save
ESC:Exit F1:General Help
��������:Move Enter:Select +/-/PU/PD:Value F10:Save
ESC:Exit F1:General Help
:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults
Disabled