Pnp/pci configurations – Foxconn BLACKOPS User Manual
Page 48
41
3
PnP/PCI Configurations
► Init Display First
This item is used to choose the initial display device which will be used first when your PC
starts up. Options are : �PCI Slot�� and �PCIEx��.
► Reset Configuration Data
Reset Configuration Data
This item is used to enable or disable the reset configuration data function.
► Resources Controlled By
This item is used to define the system resource control scheme. If all cards you use support
PnP, then select �Auto�� and the BIOS will automatically distribute interruption resources. If
the PCI cards you installed need special IRQ resources, you will need to select �Manual�� and
manually adjust interruption resources in the event of hardware conflicts.
► IRQ Resources
When "IRQ Resources" is set to "Manual", you can press the
IRQ resources.
► PCI/VGA Palette Snoop
This option is only useful if you use an MPEG card or an add-on card that makes use of the
graphics card's Feature Connector. It corrects incorrect color reproduction by "snooping"
into the graphics card's frame buffer memory and modifying (synchroni�ing) the information
delivered from the graphics card's Feature Connector to the MPEG or add-on card. It will also
solve the problem of display inversion to a black screen after using the MPEG card. Feature
Connector normally stays at top edge of the graphics card.
► INT Pin 1/2/3/4/5/6/7/8 Assignment
This item is used to assign IRQ resources for INT Pin 1/2/3/4/5/6/7/8. Default INT Pin
assignments can be found from the help menu.
Phoenix - AwardBIOS CMOS Setup Utility
PnP/PCI Configurations
Init Display First
PCI Slot
Item Help
Reset Configuration Data
Disabled
Menu Level ►
Resources Controlled By
Auto
x IRQ Resources
Press Enter
PCI/VGA Palette Snoop
Disabled
INT Pin 1 Assignment
Auto
INT Pin 2 Assignment
Auto
INT Pin 3 Assignment
Auto
INT Pin 4 Assignment
Auto
INT Pin 5 Assignment
Auto
INT Pin 6 Assignment
Auto
INT Pin 7 Assignment
Auto
INT Pin 8 Assignment
Auto
↑↓��������:Move Enter:Select +/-/PU/PD:Value F10:Save
ESC:Exit F1:General Help
��������:Move Enter:Select +/-/PU/PD:Value F10:Save
ESC:Exit F1:General Help
:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults
PCI Slot