Foxconn BLACKOPS - Manual (Page 31)

24
2
2-7 Onboard Button
Power on Button: POWeR_ON
Push the power on button to power on the system.
Reset Button: ReSeT
Push the reset button to reboot the system.
Clear CMOS Button: CLR_CMOS1
Turn off the AC power supply, push the CLR_CMOS1
button and hold there for a couple of seconds to clear
CMOS.
2-8 Onboard LeD
+5V Standby LeD:
It will light whenever the power supply that connected to
the motherboard is switched on.
DRAM Power LeD:
The LED lights up indicating the system is on or the system
is staying at S1 or S3 sleeping state.
POWER_ON RESET CLR_CMOS1
■ Make sure the power supply is turned off before pressing the CLR_CMOS1 button to
clear CMOS.
■ Push down the CLR_CMOS1 button and hold it there for a couple of seconds to clear
the CMOS completely, then release.
CA
UT
IO
N
!
Do not remove or plug in any device when the onboard LED is lighting on.
WA
RNING!