Foxconn BLACKOPS - Manual (Page 51)

44
3
Quantum BIOS
► CPU Feature / Memory Timing Config / All Voltage Control / OC Gear
Press to go to each Submenu.
► Over Clock (O.C.) Phase Select
It allows you to select the over clock phase. Setting values: �O.C. Disabled��; �Manual O.C.��;
�Instant O.C.��.
► Instant OverClocking
This item is used for instant OverClocking, you may choose over clock instantly by 5%,
10%,15%.....etc.
***Ratio and Clock Setting***
► CPU Clock Ratio Unlock
This item is used to enable or disable the CPU Clock Ratio Unlock. If CPU ratio is unlock, this
item will be hidden.
► CPU Clock Ratio
This item is used to set the ratio of an unlocked CPU. Using different CPU, the setting values
are different.
► CPU Clock Ratio +0.5x
This item allows you to set the N/2 ratio of an unlocked CPU. if CPU do not support N/2 ratio, an unlocked CPU. if CPU do not support N/2 ratio, . if CPU do not support N/2 ratio,
this item will be hidden.
► Target CPU Core Speed
This item shows target CPU core speed.
► CPU Clock(FSB)
This item allows you to set CPU clock.
► CPU Clock vs Memory Speed
When "CPU Clock Ratio" is set to "Manual O.C", this item allows you to set the ratio between
CPU Clock and Memory Speed.
► System Memory Speed
This item shows the System Memory Speed.
► PCI Express Clock
This item allows you to adjust the PCI Express bus clock.
Phoenix - AwardBIOS CMOS Setup Utility
Quantum BIOS
► CPU Feature Press Enter Item Help
► Memory Timing Config Press Enter
► All Voltage Control Press Enter Menu Level ►
► OC Gear Press Enter
Over Clock Phase Select O.C. Disabled
Instant OverClocking Default
******* Ratio and Clock Setting *******
CPU Clock Ratio Unlock Disabled
x CPU Clock Ratio 9 X
CPU Clock Ratio + 0.5x Enabled CPU Clock Ratio + 0.5x Enabled
Target CPU Core Speed 2804MHz
CPU Clock�FSB�� 266
CPU Clock vs Memory Speed Auto
System Memory Speed 800MH�
PCI Express Clock 100MH�
PCI Clock 33.6MH�
************ Miscellaneous ************
Auto Detect PCI Clk Enabled
Spread Spectrum Enabled
↑↓��������:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help ��������:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help :Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults
Press Enter