Foxconn 925XE7AA-8EKRS2 User Manual
Page 65
Chapter 3 BIOS Description
57
925XE7AA Series User Manual
PnP/PCI Configurations
Reset Configuration Data (Default: Disabled)
This option is used to set whether the system is permitted to automatically
distribute IRQ DMA and I/O addresses when each time the machine is turned
on. The setting values are: Disabled and Enabled.
Resources Controlled By (Default: Auto (ESCD))
This option is used to define the system resource control scheme. If all cards
you use support PnP, then select Auto (ESCD) and the BIOS will automatically
distribute interruption resources. If the ISA cards you installed not supporting
PnP, you will need to select “Manual” and manually adjust interruption
resources in the event of hardware conflicts. However, since this motherboard
has no ISA slot, this option does not apply.
IRQ Resources
When the Resources Controlled By set as “Manual”, this option will be
modified. Press the
PCI/VGA Palette Snoop (Default: Disabled)
If you use a nonstandard VGA card, use this option to solve graphic
acceleration card or MPEG audio card problems (e.g., colors not accurately
displayed). The setting values are Disabled and Enabled.
INT Pin 1-8 Assignment (Default: Auto)
This option is used to name the interrupt request (IRQ) line assigned to a
device connected to the PCI interface on your system.
Maximum Payload Size (Default: 4096)
This option is used to set maximum TLP payload size for PCI Express devices.
The unit is byte. The available setting values are: 128, 256, 512, 1024, 2048,
4096.
PnP/PCI Configurations Menu