Foxconn 925XE7AA-8EKRS2 - Manual (Page 49)

Chapter 3 BIOS Description
41
925XE7AA Series User Manual
First/Second/Third Boot Device (Default: Floppy/Hard Disk/CDROM)
This option allows you to set the boot device sequence. The available setting
values are: Floppy, LS120, Hard Disk, CDROM, ZIP100, USB-FDD, USB-ZIP,
USB-CDROM, Network and Disabled.
Boot Other Device (Default: Enabled)
With this function set to Enabled, the system will boot from some other
devices if the first/second/third boot devices failed. The available setting val-
ues are: Disabled and Enabled.
Swap Floppy Drive (Default: Disabled)
If you have two floppy diskette drives in your system, this item allows you to
swap the assigned drive letters. The available setting values are: Disabled
and Enabled.
Boot Up Floppy Seek (Default: Disabled)
This option controls whether the BIOS checks for a floppy drive while booting
up. If it cannot detect one (either due to improper configuration or physical
unavailability), it will appear an error message. Disable this option, POST will
not detect the floppy. The available setting values are: Disabled and
Enabled.
Boot Up NumLock Status (Default: On)
This item defines if the keyboard Num Lock key is active when your system is
started. The available setting values are: On and Off.
Gate A20 Option (Default: Fast)
This option is used to set up the A20 signal control necessary for access to
the 1MB memory. The available setting values are: Normal and Fast.
Typematic Rate Setting (Default: Disabled)
If this item is enabled, you can use the following two items to see the typematic
rate and the typematic delay settings for your keyboard. The available setting
values are: Disabled and Enabled.
Typematic Rate (Chars/Sec) (Default: 6)
Use this item to define how many characters per second a held-down key
generated.
Typematic Delay (Msec) (Default: 250)
Use this item to define how many milliseconds must elapse before a held-
down key begins generating repeat characters.