Foxconn 655A01-FX-6LRS - Manual (Page 29)

21
655A01 Series User Manual
Chapter 2 Installation Instructions
Other Connectors
This motherboard includes connectors for FDD, IDE HDD, USB, CPU/system
fan, and others.
FDD Connector: Floppy
This motherboard includes a standard FDD connector, supporting 360K,
720K, 1.2M, 1.44M and 2.88M FDDs.
FDD connector
HDD Connectors: PIDE & SIDE
This connectors supports the provided UltraDMA 133/100/66/33 IDE hard
disk ribbon cable. Connect the cable’s blue connector to the primary
(recommended) or secondary IDE connector, then connect the gray connector
to the Ultra DMA 133/100/66/33 slave device (hard disk drive) and the black
connector to the Ultra DMA 133/100/66/33 master device. If you install two hard
disks, you must configure the second drive as a slave device by setting its
jumper accordingly. Refer to the hard disk documentation for the jumper
settings.
Attention:
Ribbon cables are directional, therefore, make sure to always
connect with the cable on the same side as pin 1 of the PIDE/
SIDE or FDD connector on the motherboard.
1