Foxconn Rattler - Manual (Page 38)

3
31
► USB Transfer time-out
This item is used to select a time-out value for Control,Bulk and Interrupt Transfers. Default
value is [20 sec].
► Device reset time-out
This item is used to select the USB mass storage device start unit command time-out. Default
value is [20 sec].
► Device power-up delay
This item is used to set the maximum time the device will take before it can report itself to the
host controller.
[Auto] : This is default option. For a root port, the default time is 100ms. For a hub port, the
delay is taken from hub descriptor.
[Manual]: you can change the time you want by the following item.
► Device Power-up delay in seconds(Only appears when set “Device power-up delay” to
[Manual])
You can change the value by pressing “+/-” keys, or input the number you want directly. The
value can be changed from 5 to 40.