4 install a new windows xp – Foxconn Rattler User Manual

Page 102

5-4 Install a New Windows XP

1. Press to enter BIOS Setup during POST.
2. Insert the Windows installation CD into the optical drive.
3. Set the “Boot Option #1” to “SATA: ATAPI DVD ...”, save changes and exit the BIOS

setup.

4. The computer will reboot, and it will start installing Windows Operating System.
Watch the screen carefully, when the following picture appears, press key

immediately. If you forgot to do this, PC will go to an fatal blue screen, and you
may need to reboot the system again. PC may not respond to your input
immediately, and it keeps loading files until the next screen displays.

Windows Setup

Press F6 if you need to install a third party SCSI or RAID driver.

Main Advanced Chipset Boot Security Save & Exit Quantum BIOS

Boot Configuration

Setup Prompt Timeout

Bootup Numlock State

[On]

Quiet Boot

[Enabled]

Fast Boot

[Disabled]

CSM16 Module Version

07.64

Option ROM Messages

[Force BIOS]

Interrupt 19 Capture

[Disabled]

HDD BootSector Write

[Normal]

ZIP Emulation Type

[Floppy]

Boot Option Priorities

Boot Option #1

[SATA: ATAPIDVD ...]

Hard Drive BBS Priorities

→ ←: Select Screen
↑ ↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values

F3: Optimized Defaults
F4: Save & Exit
ESC: Exit

Sets the system boot order

Boot

When set the SATA Mode in BIOS to IDE, you can install Windows XP directly.

When set the SATA Mode in BIOS to either AHCI or RAID, you need to

follow the following steps to install Windows XP.