Foxconn K8S760MG-6ELRS - Manual (Page 63)

56
Chapter 3 BIOS Description
PM Wake Up Events Menu
IRQ [3-7, 9-15], NMI (Default: Enabled)
This option is used to enable or disable IRQ[3-7,9-15], NMI.
IRQ 8 Break Suspend (Default: Disabled)
This option is used to enable or disable IRQ8 Break Suspend.
RING Power Up Control (Default: Enabled)
If this option is enabled, it allows the system to resume from a software power
down or power saving mode whenever there is an incoming call to an installed
fax/modem. This function needs to be supported by the relevant hardware
and software. The setting values are: Disabled and Enabled.
MACPME Power Up Control (Default: Enabled)
This option is used to enable or disable the system to be waken up by onboard
LAN.
PCIPME Power Up Control (Default: Enabled)
This option is used to enable or disable the system to be waken up by PCI
card.
PS2KB Wakeup from S3/S4/S5 (Default: Hot Key)
This option is used to set which action will wake up PS/2 keyboard from S3/
S4/S5 status. The hotkey is Ctrl+Alt+Backspace. The setting values are Any
Key, Hot Key, Password.
PS2MS Wakeup from S3/S4/S5 (Default: Click)
This option is used to set which action will wake up PS/2 mouse from S3/S4/
S5 status. The setting values are: Disabled, Click, Move & Click.
Power UP by Alarm (Default: Disabled)
This option is used to set the timing of the start-up function. In order to use this
function, the start-up password function must be cancelled. Also, the PC power
source must not be turned off. The setting values are: Disabled and Enabled.
Ｋ８Ｓ７６０ＭＧ－ＷＩＮＦＡＳＴ－Ｖ１．０ ．ｐ６５ 2004-9-14, 8:42 56