Foxconn K8S760MG-6ELRS - Manual (Page 60)

53
Chapter 3 BIOS Description
Onboard FDC Controller (Default: Enabled)
This option is used to set whether the onboard FDC controller is enabled.
The available setting values are: Disabled and Enabled.
Onboard Serial Port 1/2 (Default: 3F8/IRQ4 / 2F8/IRQ3)
These options are used to assign the I/O address and interrupt request
(IRQ) for the onboard serial port 1/2.
Note: Do not try to set the same values for serial port 1 and 2.
UART Mode Select (Default: Normal)
Use this option to select the UART mode. Setting values include Normal,
IrDA, ASKIR and SCR. The setting value is determined by the infrared module
installed on the board.
UR2 Duplex Mode (Default: Half)
This option is available when UART 2 mode is set to either ASKIR or IRDA. This
option enables you to determine the infrared function of the onboard infrared
chip. The available setting values are: Half and Full.
Onboard Parallel Port (Default: 378/IRQ7)
This option allows you to determine onboard parallel port controller I/O ad-
dress and interrupt request (IRQ). Setting values include: Disabled, 378/IRQ7,
278/IRQ5 and 3BC/IRQ7.
Parallel Port Mode (Default: SPP)
Select an address and corresponding interrupt request for the onboard parallel
port. Setting values include SPP, EPP, ECP, ECP+EPP.
ECP Mode Use DMA (Default: 3)
Select a DMA channel for the parallel port when using the ECP mode. This field
is only configurable if Parallel Port Mode is set to ECP. The available setting
values are: 3 and 1.
Onboard SuperIO Device Menu
Ｋ８Ｓ７６０ＭＧ－ＷＩＮＦＡＳＴ－Ｖ１．０ ．ｐ６５ 2004-9-14, 8:42 53