Foxconn K8S760MG-6ELRS - Manual (Page 50)

43
Chapter 3 BIOS Description
Security Option (Default: Setup)
When it is set to Setup, a password is required to enter the CMOS Setup
screen; when it is set to System, a password is required not only to enter
CMOS Setup, but also to startup your PC, as well.
APIC Mode (Default: Enabled)
This option is used to enable or disable APIC mode.
MPS Version Control For OS (Default: 1.4)
This option is used to set up the version of MPS Table used in NT4.0 OS.
OS Select For DRAM > 64 MB (Default: Non-OS2)
This option is required only if you have installed more than 64 MB of memory
and you are running the OS/2 operating system. Otherwise, leave this option
at the default.
HDD S.M.A.R.T. Capability (Default: Disabled)
This option is used to enable or disable hard disk's S.M.A.R.T. support function.
The available setting values are: Disabled and Enabled.
Report No FDD For WIN 95 (Default: Yes)
If you are using the Windows 95 and running a system with no floppy drive,
select “Yes” for this option to ensure compatibility with Windows 95 logo
certification. The available setting values are: No and Yes.
Video BIOS Shadow (Default: Enabled)
This option is used to enable or disable Video BIOS Shadow. If you enable
this option, the video BIOS will be copied to RAM. Video shadow will increase
the video speed. The available setting values are: Disabled and Enabled.
Full Screen LOGO Show (Default: Enabled)
This option allows you to enable or disable the full screen logo. The available
setting values are: Disabled and Enabled.
Small Logo (EPA) Show (Default: Disabled)
This option allows you to enable or disable the EPA logo. The available setting
values are: Disabled and Enabled.
Ｋ８Ｓ７６０ＭＧ－ＷＩＮＦＡＳＴ－Ｖ１．０ ．ｐ６５ 2004-9-14, 8:42 43