Foxconn K8S760MG-6ELRS - Manual (Page 32)

25
Chapter 2 Installation Instructions
Audio Interface: F_AUDIO
The audio interface provides two kinds of audio output choices: the Front Audio,
the Rear Audio. Their priority is sequenced from high to low (Front Audio to Rear
Audio). If headphones are plugged into the front panel of the chassis (using the
Front Audio), then the Line-out (Rear Audio) on the rear panel will not work. If you
do not want to use the Front Audio, pin 5 and 6, pin 9 and 10 must be shorted,
and then the signal will be sent to the rear audio port.
Speaker Connector: SPK
The speaker connector is used to connect speaker of the chassis.
SPEAKER
SPK
SPKJ
Emypty
NC
1
F_AUDIO
MIC_GND MIC
+5VAC MIC_PWR
AUT_RET_R AUD_OUT_R
EMPTY
AUD_OUT_L AUT_RET_L
1 2
9 10
NC
Ｋ８Ｓ７６０ＭＧ－ＷＩＮＦＡＳＴ－Ｖ１．０ ．ｐ６５ 2004-9-14, 8:41 25