Foxconn K8S760MG-6ELRS - Manual (Page 30)

23
Chapter 2 Installation Instructions
1394 Header: F_1394 (optional)
The 1394 expansion cable can be connected to either the front (provided that
the front panel of your chassis is equipped with the appropriate interface) or
rear panel of the chassis.
Wake-up On LAN: WOL
Through the Wake-Up On LAN function, a wake event occurring from the net-
work can wake up the system. To utilize this function, please be sure to use an
ATX 12 V power supply with a 5VSB line capable of delivering a current of at least
1 A, and a LAN adapter which supports this function. Then connect the header to
the relevant connector on the LAN adapter, set “MACPME Power Up Control” to
“Enabled” in the “Power Management Setup” section of the CMOS SETUP. Save
and exit, then boot the operating system once to make sure this function takes
effect.
WOL
Signal for waking up
+5VSB
GND
1
F_1394
Empty
Ｋ８Ｓ７６０ＭＧ－ＷＩＮＦＡＳＴ－Ｖ１．０ ．ｐ６５ 2004-9-14, 8:41 23