Foxconn IGPSK7MA-ERS - Manual (Page 63)

Chapter 5 nVIDIA RAID Introduction
56
13. Select Convert Array under the System Tasks. The Convert Array wizard
is displayed. Then select Next.
14. Select the desired type of RAID array you want to convert. Then select
Next.
15. You are prompted to select the desired Free Disk(s) to add to the
bootable RAID array.
16. Click Finish.
At this point, NVRAID starts converting the single disk RAID array into a multi-
disk RAID array in a bootable format.
Note: Conversion may take 1-2 hours depending on disk size.
II) The user must create a combination installation CD that includes
Windows 2000 and SP3 or SP4 fixes integrated in. To create the
combination installation CD, refer to the following website:
http://www.microsoft.com/windows2000/downloads/servicepacks/sp4/
HFdeploy.htm
Note: If the end user chooses not to install Windows 2000 Service Pack 3 or
4, RAID is still supported on Windows 2000. However, the end user will not
be able to create a bootable RAID volume.
ＩＧＰＳＫ７ＭＡ－ｍａｎｕａｌ－Ｖ１．０－１１－１３－０４．ｐ６５ 2004-11-15, 17:37 56