Foxconn IGPSK7MA-ERS - Manual (Page 18)

Chapter 2 Installation Instructions
11
Power Supply
This motherboard uses an ATX power supply. In order to avoid damaging any
devices, make sure that they have been installed properly prior to connecting
the power supply.
20-pin ATX power Connector: PWR1
PWR1 is the ATX power supply connector. Make
sure that the power supply cable and pins are
properly aligned with the connector on the
motherboard. Firmly plug the power supply cable
into the connector and make sure it is secure.
20-pin ATX power connector
Attention:
You have to press the power button for more than four seconds if
you change the default “Instant-Off” setting to “Delay 4 Sec”
from the “Soft-Off by PBTN” option in the BIOS Power Manage-
ment Setup.
20
10
12V
5VSB
5V
GND 3.3V GND
5V
GND
PW-OK 3.3V
11
1
5V GND 3.3V GND GND
5 V -5V GND PS-ON -12V
ＩＧＰＳＫ７ＭＡ－ｍａｎｕａｌ－Ｖ１．０－１１－１３－０４．ｐ６５ 2004-11-15, 17:36 11