Foxconn IGPSK7MA-ERS - Manual (Page 24)

Chapter 2 Installation Instructions
17
Note:
1. You must install the driver before you use the USB 2.0 function.
2. NEVER connect a 1394 cable to the F_USB1 or F_USB2
connectors. Doing so will damage the motherboard.
Addtional COM Header: COM2
This motherboard provides an additional serial COM
header for your machine.
Connect one side of a switching cable to the header,
then attach the serial COM device to the other side of
the cable.
COM2
IrDA Header: IR
This connector supports wireless transmitting and re-
ceiving device. Before using this function, configure
the settings of IR Mode from the “Integrated Peripher-
als” section of the CMOS Setup.
1
IR
+5V IRRX IRTX
Empty
GND
1394 Header: F_1394 (optional)
The 1394 expansion cable can be connected to either
the front (provided that the front panel of your chassis
is equipped with the appropriate interface) or rear
panel of the chassis.
F_1394
TPB-
GND
+12V
TPA -
1 2
9 10
+12V
TPB +
GND
Empty
TPA +
SOUT
GND RI
DTR
DSR SIN
CTS
RTS
Empty
9
10
1
2
ＩＧＰＳＫ７ＭＡ－ｍａｎｕａｌ－Ｖ１．０－１１－１３－０４．ｐ６５ 2004-11-15, 17:36 17