Foxconn IGPSK7MA-ERS - Manual (Page 40)

Chapter 3 BIOS Description
33
™
MAC Media Interface (Default: MII)
When set as “Auto”, it allows the BIOS to auto-detect the nVIDIA LAN control-
ler and enable it. The setting options are Auto and Disabled.
™ Machine MAC(NV) Address (Default: Disabled)
This option
™
MAC(NV) Address Input
When Machine MAC(NV) Address is setting to “Enabled”, you can select the
option and key in MAC address.
™ IDE HDD Block Mode (Default: Enabled)
This option is used to set whether the IDE HDD Block Mode is allowed. The
available setting values are Disabled and Enabled.
™ POWER ON Function (Default: BUTTON ONLY)
This option is used to set the power on method for your PC. Setting values
include: Password, Hot KEY, Mouse Move, Mouse Click, Any KEY, BUTTON
ONLY and Keyboard 98.
™
KB Power ON Password (Default: Enter)
When the POWER ON Function is set to Password, use this item to set the
password.
™
Hot Key Power ON (Default: Ctrl-F1)
When the POWER ON Function is set to Hot KEY, use this item to set the hot
key combination that turns on the system. The available setting values are:
Ctrl-F1-F12.
™ Onboard Serial Port 1/2 (Default: 3F8/IRQ4/2F8/IRQ3)
This option is used to assign the I/O address and interrupt request (IRQ)
for the onboard serial port 1/2.
Note: Do not try to set the same values for serial port 1 and 2.
™ UART Mode Select (Default: Normal)
Use this option to select the UART mode. The setting values include Normal,
IrDA, ASKIR and SCR. The setting value is determined by the infrared module
installed on the board.
™ UR2 Duplex Mode (Default: Half)
This option is available when UART 2 mode is set to either ASKIR or IRDA. This
option enables you to determine the infrared (IR) function of the onboard infra-
red chip. The available setting values are: Half and Full.
ＩＧＰＳＫ７ＭＡ－ｍａｎｕａｌ－Ｖ１．０－１１－１３－０４．ｐ６５ 2004-11-15, 17:36 33